Chain & Connectors

Sash Chain
Sash Chain should be selected for it's material, load rating and size. We also offer a range of specialist chain pulleys.

Chain Connectors

Either of the three connectors are required to attach the chain to the lead weight; Bolt connector, Plate and Bar Connector or Washer and Split pin Connector. These should be selected to match the chain size.

Bolt Connector Instructions:
Thread the connector through the weight, tighten bottom nut, then attach chain.

Plate and Bar Connector Instructions:
Screw plate to lead and attach chain.

Washer and Split Pin Connetor Instructions:
Thread the chain through the weight, then the washer, with the pin connected though the chain under the washer.

Weight Pulley

Instructions: Screw the grub screw [included] into the 10mm hole at the top of the lad bad, then screw in the pulley. Suitable for use with Reddiseals Lead.